N-101

Specification
AWS Specification: AWS A5.1 E6019
JIS Specification: D4301
Other Specification: 
Description
  • N-101 is a ilmenite type electrode designed for puting emphasis  on both usability and weldability
  • It is suitable  for butt or fillet welding in all positions for thin or thicker plates (1.6 to 20mm)
  • In horizontal fillet welding, slag covering and bead uniformity are good and bead appearance is beautiful
  • Vertical or overhead welding is best among ilmenite type of electrodes

 

TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

P

S

0.08

0.07

0.51

0.012

0.007

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point
N/mm2 (KSI)
 
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 
Impact Value
°C, J (°F, Ft-Lbs)
 

410 (60)

460 (67)

32

-18°, 80  (0°, 59)

 

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)

2.6

3.2

4.0

5.0

LENGTH (mm)

350

350

350

350

Current Amp

Flat

50 - 80

70 - 110

120 – 160 

160 - 200

Vertical Overhead

40 - 70

60 - 100

110 - 150

140 - 180


Welding Positions: ALL POSITIONS EXCEPT VERTICAL DOWN
Approvals: ABS, BV, DNV, LRS

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • Welding of  heavy-duty structures such as ships, vehicles, buildings and bridges
  • Pay attention not to exceed the range of proper currents
  • Welding with excessive current not only lowers X-ray soundness, but also causes increase of spatter, under-cut, and insufficient slag covering
  • Dry the electrodes at 70-100C for 30-60 minutes before use
  • Excessive moisture absorption lowers usability and may result in porosity
  • Excessive drying before use causes less in penetration and overheating of the electrode

ABOUT US

For over 37 years, NIHONWELD has been the market leader of high quality welding electrodes in both the domestic and international markets. With Nihonweld, you will WELD WITH COMPLETE CONFIDENCE.
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines