N-101

Specification

AWS Specification: AWS A5.1 E6019
JIS Specification: D4301
Other Specification:

Description

N-101 is a ilmenite type electrode designed for puting emphasis on both usability and weldability
It is suitable for butt or fillet welding in all positions for thin or thicker plates (1.6 to 20mm)
In horizontal fillet welding, slag covering and bead uniformity are good and bead appearance is beautiful
Vertical or overhead welding is best among ilmenite type of electrodes

Application

Welding of heavy-duty structures such as ships, vehicles, buildings and bridges

Remarks

Pay attention not to exceed the range of proper currents

Welding with excessive current not only lowers X-ray soundness, but also causes increase of spatter, under-cut, and insufficient slag covering

Dry the electrodes at 70-100�C for 30-60 minutes before use

Excessive moisture absorption lowers usability and may result in porosity

Excessive drying before use causes less in penetration and overheating of the electrode

Technical Data

TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C	Si	Mn	P	S
0.08	0.07	0.51	0.012	0.007

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:

Yield Point N/mm² (KSI)	Tensile Strength N/mm² (KSI)	Elongation %	Impact Value °C, J (°F, Ft-Lbs)
410 (60)	460 (67)	32	-18°, 80 (0°, 59)

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)		2.6	3.2	4.0	5.0
LENGTH (mm)		350	350	350	350
Current Amp	Flat	50 - 80	70 - 110	120 – 160	160 - 200
Current Amp	Vertical Overhead	40 - 70	60 - 100	110 - 150	140 - 180

Welding Positions:	ALL POSITIONS EXCEPT VERTICAL DOWN
Approvals:	ABS, BV, DNV.GL, LRS

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.