NSF-18 (FLUX) / NSW-L12 (WIRE)

Specification
AWS Specification: AWS A5.17 F7A0-EL12
JIS Specification: N/A
Other Specification: N/A
Description
  • NSF-18 (FLUX) is an agglomerated bonded type flux that features resistant to porosity and good mechanical properties
  • NSW-L12 (WIRE) is a general purpose wire that contains less carbon, manganese, and silicon than many other submerged arc wires, therefore yielding less strength but providing greater resistance to cracking
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

P

S

0.07

0.52

1.14

0.014

0.012

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point
N/mm2 (KSI)
 
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 
Impact Value
°C, J (°F, Ft-Lbs)
 

480 (70)

550 (80)

28

-18°, 105  (0°, 77)

 

WIRE SIZES AVAILABLE:

DIAMETER (mm)

2.0

2.4

3.2

4.0

4.8


NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • For single pass and high speed welding for thin plate of mild steel and 490 N/mm2 H.T. steel
  • Wire Packing: 25 KG per coil
  • Flux Packing: 25 KG per sack

about us

Industrial Welding Corporation (IWC) was established in 1982 by Mr. H. Ong Hai who had 25 years of welding industry experience (at that time). Since then, IWC has consistently and successfully earned an excellent ...
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines