NT-08R

Specification
AWS Specification: AWS A5.2 R45
JIS Specification: N/A
Other Specification: N/A
Description
  • NT-08R is a copper coated gas welding rod that is used for welding ordinary low carbon steel up to 1/4” thick
  • Recommended for brazing where ductility and machinability are most important
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

S

P

Fe

0.08

0.07

0.42

0.025

0.025

Bal.

 

SIZES AVAILABLE:

DIAMETER (mm)

1.6 - 5.0


NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • General purpose oxyfuel rod for welding mild steels
  • Clean joint and bevel heavy sections keeping torch tip at low angle to base metal

about us

Industrial Welding Corporation (IWC) was established in 1982 by Mr. H. Ong Hai who had 25 years of welding industry experience (at that time). Since then, IWC has consistently and successfully earned an excellent ...
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines