SHIELD METAL ARC WELDING (SMAW)

 Printer Friendly Layout

CUTROD

Specification
AWS Specification: N/A
JIS Specification: N/A
Other Specification: N/A
Description
  • CUTROD is designed for high-speed, all position cutting and piercing of all metals using standard electric arc equipment
  • Ideal for cutting and piercing mild carbon steel, stainless steel, cast iron, malleable iron, nickel and nickel alloys, aluminum, copper, and bronze
  • Slow burn-off rate leaves little residue, thereby less finishing necessary
  • Can withstand high amperage and does not overheat
SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)

3.2

4.0

5.0

LENGTH (mm)

350

350

350

Current Amp

150 - 200

180 - 250

200 - 300

 

Welding Positions: FLAT, FILLET, VERTICAL UP, OVERHEAD
Approvals: N/A

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • For cutting and piercing of all kinds of metals, stainless steels, cast iron, and all kinds of non-ferrous metals
  • Mark or scribe line where cut is desired
  • No special holder or compressed air needed
  • Use both the arc-blow caused by exothermic coating plus pressure with hand
  • When arc is struck, push and pull, holding the electrode at a 45º angle and using a sawing motion to cut
  • The closer the arc, the faster, cleaner, and cooler the cut
  • For piercing holes, hold the electrode vertically, then push in and out

ABOUT US

For over 40 years, NIHONWELD has been the market leader of high quality welding electrodes in both the domestic and international markets. With Nihonweld, you will WELD WITH COMPLETE CONFIDENCE.
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines