SHIELD METAL ARC WELDING (SMAW)

 Printer Friendly Layout

N-NiCrFe-1

Specification
AWS Specification: AWS A5.11 ENiCrFe-1
JIS Specification: N/A
Other Specification: N/A
Description
  • N-Ni-CrFe-1 is a nickel-chromium-iron flux-coated electrode designed primarily for welding Inconel® 600 and Incoloy® 825
  • Corrosion resistant over a wide range of environmentals ranging from cryogenic temperatures to approximately 820ºC
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

Fe

Ni

 Cr Nb & Ta

0.04

0.45

2.81

7.78

Bal.

 15.53 2.78

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point
N/mm2 (KSI)
 
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 
Impact Value
°C, J (°F, Ft-Lbs)
 

623 (90)

382 (55)

42

-196°, 88  (-132°, 65)

 

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)

3.2

4.0

5.0

LENGTH (mm)

350

350

350

Current Amp

Flat

70 - 110

100 - 150 

130 - 180

Vertical & Overhead

65 - 105

95 - 140

-

Welding Positions: FLAT, FILLET, VERTICAL UP, HORIZONTAL, OVERHEAD
Approvals: N/A

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • Used in chemical and food industries 
  • Welding the clad side of joints in steel clad with Inconel® 600 and for surfacing steel
  • Common ASTM base metals that can be joined are ASTM B163, B166, B167, and B168
  • Preheating is not necessary
  • Avoid continuous welding
  • Effective to weld under 150ºC for reduced cracking tendency
  • Dry the electrodes at 150 - 200ºC for 30 - 60 minutes before use

ABOUT US

For over 40 years, NIHONWELD has been the market leader of high quality welding electrodes in both the domestic and international markets. With Nihonweld, you will WELD WITH COMPLETE CONFIDENCE.
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines