N-11

Specification
AWS Specification: AWS A5.1 E6011
JIS Specification: D4311
Other Specification: DIN E4343C4
Description
  • N-11 is a cellulosic type electrode for mild steel designed for AC power use
  • The strong arc force and rapid solidification of metal facilitate welding in the vertical and overhead positions
  • The arc can be directed easily in any position with light slag formation and minimum spatter loss
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C

Si

Mn

P

S

0.11

0.22

0.42

0.015

0.012

 

TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point
N/mm2 (KSI)
 
Tensile Strength
N/mm2 (KSI)
 
Elongation
%
 
Impact Value
°C, J (°F, Ft-Lbs)
 

420  (61)

490 (71)

30

-29°, 80  (-20°, 59)

 

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+), DC (-)

DIAMETER (mm)

2.6

3.2

4.0

5.0

LENGTH (mm)

350

350

350

350

Current Amp

Flat

50 - 80

70 - 110

120 – 160 

160 - 200

Vertical & Overhead

40 - 70

60 - 100

110 - 150

140 - 180


Welding Positions: ALL POSITIONS INCLUDING VERTICAL DOWN
Approvals: ABS

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

  • Welding of pipes and general structures
  • Pay attention not to exceed the range of the recommended welding currents because the proper currents for cellulose type electrodes are lower in comparison with those for ordinary type electrodes
  • Dry the electrodes at 70-100 degrees C for 30-60 minutes before use
  • Excessive moisture absorption lowers usability and may result in porosity
  • Excessive drying before use may result in lesser penetration and overheating of the electrode
  • For Philippine market only

about us

Industrial Welding Corporation (IWC) was established in 1982 by Mr. H. Ong Hai who had 25 years of welding industry experience (at that time). Since then, IWC has consistently and successfully earned an excellent ...
Copyright © 2018 Industrial Welding Corporation
Web Design By WebToGo Philippines