NSF-350 (FLUX) / NSW-L12 (WIRE)
Specification
JIS Specification: N/A
Other Specification: N/A
Description
- NSF-350 (FLUX) is an agglomerated bonded type flux that features high deposition rate and specially designed for metal-to-metal wear applications
- NSW-L12 (WIRE) is a general purpose wire that contains less carbon, manganese, and silicon than other submerged arc wires, therefore yielding less strenght but providing greater resistance to cracking
Application
- Excavator parts
- Caterpillar tractors
- Bearings
Remarks
Technical Data
TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):
|
C |
Si |
Mn |
Cr |
Mo |
|
0.20 |
0.75 |
1.43 |
2.73 |
0.45 |
TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
|
Condition
|
Typical Hardness (Brinnell)
|
|
1st Pass |
335 |
|
2nd Pass |
428 |
|
3rd Pass |
450 |
WIRE SIZES AVAILABLE:
|
DIAMETER (mm) |
2.4 |
3.2 |
4.0 |
4.8 |
|
NOTE:
The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.