CUTROD

Specification

AWS Specification: N/A
JIS Specification: N/A
Other Specification: N/A

Description

CUTROD is designed for high-speed, all position cutting and piercing of all metals using standard electric arc equipment
Ideal for cutting and piercing mild carbon steel, stainless steel, cast iron, malleable iron, nickel and nickel alloys, aluminum, copper, and bronze
Slow burn-off rate leaves little residue, thereby less finishing necessary
Can withstand high amperage and does not overheat

Application

For cutting and piercing of all kinds of metals, stainless steels, cast iron, and all kinds of non-ferrous metals

Remarks

Mark or scribe line where cut is desired

No special holder or compressed air needed

Use both the arc-blow caused by exothermic coating plus pressure with hand

When arc is struck, push and pull, holding the electrode at a 45� angle and using a sawing motion to cut

The closer the arc, the faster, cleaner, and cooler the cut

For piercing holes, hold the electrode vertically, then push in and out

Technical Data

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)	3.2	4.0	5.0
LENGTH (mm)	350	350	350
Current Amp	150 - 200	180 - 250	200 - 300

Welding Positions:	FLAT, FILLET, VERTICAL UP, OVERHEAD
Approvals:	N/A

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.