N-12016-G

Specification

AWS Specification: AWS A5.5 E12016-G
JIS Specification: E8316-G
Other Specification: N/A

Description

Application

Remarks

  • Dry the electrodes at 350-400°C for about one hour before use
  • Adopt back step method or strike the arc on a small steel plate to prevent blowholes at the arc starting
  • Keep the arc as short as possible
  • Technical Data

    TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

    C

    Si

    Mn

    P

    S

    Ni Cr Mo

    0.07

    0.45

    1.28

    0.009

    0.006

    1.85 0.80 0.41

     

    TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
    Yield Point
    N/mm2 (KSI)
     
    Tensile Strength
    N/mm2 (KSI)
     
    Elongation
    %
     
    Impact Value
    °C, J (°F, Ft-Lbs)
     

    790  (115)

    920 (133)

    23

    -51°, 60  (-60°, 44)

     

    SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

    DIAMETER (mm)

    2.6

    3.2

    4.0

    5.0

    LENGTH (mm)

    350

    350

    350

    350

    Current Amp

    Flat

    55 - 85

    90- 130

    135 - 185

    190 - 250

    Vertical & Overhead

    50 - 80

    80 - 120

    110 - 160

    165 - 210


    Welding Positions: ALL POSITIONS 
    Approvals: N/A

    NOTE:

    The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.