N-7016-A1

Specification

AWS Specification: AWS A5.5 E7016-A1
JIS Specification: DT1216
Other Specification: N/A

Description

Application

Remarks

  • Dry the electrodes at 325-375C for about one hour before use
  • Pre-heat at 250-350C and post-heat at 730-760C
  • Technical Data

    TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

    C

    Si

    Mn

    Cr

    Mo

    0.07

    0.54

    0.83

    -

    0.52



    TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
    Yield Point
    N/mm2 (KSI)
     
    Tensile Strength
    N/mm2 (KSI)
     
    Elongation
    %
     
    PWHT
     

    560  (81)

    650 (94)

    31

    620°C x 2 hrs.


     

    SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

    DIAMETER (mm)

    2.5

    3.2

    4.0

    5.0

    LENGTH (mm)

    350

    350

    400

    400

    Current Amp

    Flat

    55 - 85

    90 - 130

    140 - 190

    190 - 240

    Vertical & Overhead

    50 - 80

    80 - 120

    110 - 170

    -


    Welding Positions: ALL POSITIONS EXCEPT VERTICAL DOWN
    Approvals: N/A

    NOTE:

    The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.