TOOLKORD

Specification

Description

• TOOLKORD is a basic type electrode with coating for manufacturing and repairing high-speed cutting tools

Application

• Welding of cutting tools (e.g. for turning, planning, milling, reaming, drills, etc.)

Remarks

Preheat the workpiece up to 600-700ºC and maintain this temperature during welding

Weld at the lowest amperage

Technical Data

TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

C	Si	Mn	Cr	Mo	V
0.90	0.50	0.50	4.20	8.50	0.90

 

HARDNESS OF WELD METAL:

Hardness	Vickers (Hv)	Rockwell (HRC)
As Welded	510 - 840	50 - 64
Work Hardened	790 - 890	62 - 66

 

SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

DIAMETER (mm)	2.6	3.2	4.0
LENGTH (mm)	300	350	350
Current Amp	70 - 100	100 - 150	130 - 180

 

Welding Positions:	FLAT, HORIZONTAL, OVERHEAD, VERTICAL
Approvals:	N/A

NOTE:

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.