N-14

Specification

AWS Specification: AWS A5.1 E6019
JIS Specification: D4301
Other Specification: 

Description

Application

 

Remarks

  • If coating flux absorbs excessive moisture, arc and slag fluidity will become unstable resulting in increased spatters, undercuts, and blowholes
  • Damp electrodes should be re-dried at 70-120°C for 60 minutes
  • Excessive high current and wide weaving deteriorate X-ray quality
  • Use optimum current and limit weaving width to within 2.5 times of the electrode diameter

    • Technical Data

    TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):

    C

    Si

    Mn

    P

    S

    0.10

    0.10

    0.46

    0.014

    0.01

     

    TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
    Yield Point
    N/mm2 (KSI)
     
    Tensile Strength
    N/mm2 (KSI)
     
    Elongation
    %
     
    Impact Value
    °C, J (°F, Ft-Lbs)
     

    410  (60)

    460 (67)

    32

    -18°, 80  (0°, 59)

     

    SIZE AND RECOMMENDED CURRENT RANGE: AC, DC (+)

    DIAMETER (mm)

    2.6

    3.2

    4.0

    5.0

    LENGTH (mm)

    350

    350

    350

    350

    Current Amp

    Flat

    55 - 90

    85 - 140

    130 - 190

    180 -260

    Vertical & Overhead

    40 - 80

    60 - 120

    100 - 160

    135 - 210

    Welding Positions: ALL POSITIONS EXCEPT VERTICAL DOWN
    Approvals: N/A

    NOTE:

    The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and test results for mechanical properties, deposit, or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design, and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.