nihonweldnihonweldnihonweld

Printer Friendly Layout
NT-410 / NM-410
AWS Specification: ER-410
JIS Specification:

NONE

Other Specification:

FOR STAINLESS STEEL

I. APPLICATIONS:

For welding types 403, 405, 410 and 416. Also used as overlay on carbon steels to resist corrosion, erosion or abrasion.

II. DESCRIPTIONS:

NT-410/NM-410 is used to weld Types 403, 405, 410 and 416. It is also used for welding overlay on carbon steels to resist corrosion, erosion and abrasion. This material, being of the air hardening type, calls for preheating of the joint to 350°F before welding. It is suitable for use against corrosion from atmosphere, fresh water, and mild acids.

III. TYPICAL CHEMICAL COMPOSITION OF WELD METAL (%): 

 

C

Si

Mn

Cr

Ni

Mo

0.06

0.41

0.53

12.93

0.42

0.16

IV. TYPICAL MECHANICAL PROPERTIES OF WELD METAL : AT 850° C x 2 hr  

 

Tensile Strength N/mm2 (Ksi)

Yield Point

N/mm2 (Ksi)

Elongation %

530 (77)

310 (45)

35

V. SIZES AVAILABLE : 

 

Dia.(mm)

1.6

2.0

2.4

3.2

4.0

Length (mm)

1000

1000

1000

1000

1000

Unit wt./packing (kgs.)

5.0

5.0

5.0

5.0

5.0

VI. MIG AVAILABLE SIZES AND RECOMMENDED CURRENT: 

 

Size (dia.x length) mm

Amps

0.8 x spool

60-180

0.9 x spool

70-200

1.0 x spool

70-200

1.2 x spool

90-250

1.6 x spool

200-300

 TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.