nihonweldnihonweldnihonweld

Printer Friendly Layout
NIHONCUT
NIHONCUT
AWS Specification: none
JIS Specification:

none

Other Specification:

I. APPLICATIONS:

For cutting and piercing all kinds of metals, stainless steels, cast iron and all kinds of non-ferrous metals.

II. DESCRIPTION:

For highest speed, all position cutting and piercing of all metals using standard electric arc equipment. Ideal for cutting and piercing mild carbon steel, stainless steel, cast iron, malleable iron, nickel and nickel alloys, aluminum, copper, bronze. No special skill, supplementary equipment or oxygen tanks are required. Slow burn-off rate leaves little residue, requiring comparably less finishing. NIHONCUT does not overheat, can withstand high amperage.

III. NOTES ON USAGE:

Mark or scribe line where cut is desired. On DC, use straight polarity. No special holder or compressed air needed. When applying NIHONCUT electrode, use both the arc-blow, caused by the exothermic coating, plus pressure with the hand. When arc is struck, push and pull, holding electrode at a 45º angle and using a sawing motion to cut. The closer the arc, the faster, cleaner, cooler the cut. For piercing holes, hold NIHONCUT vertically, and push in and out.

IV. WELDING POSITIONS: FLAT, FILLET, VERTICAL UP, OVERHEAD

V. SIZES AVAILABLE AND RECOMMENDED CURRENTS : AC or DC (+ )

 

Size

(mm)

Dia.

3.2

4

5

Length

450

450

450

Current Range Amp

150~200

180~250

200~300

 

 TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.