nihonweldnihonweldnihonweld

Printer Friendly Layout
NIHONWELD NSS-316L-17
AWS Specification: E316L-17
JIS Specification:

NONE

Other Specification:

I. APPLICATIONS:

NSS-316L-17 electrodes are used for welding the corresponding steel grade, i.e. AISI 316 and 316L but can also be used, under certain conditions, for welding ferritic-austenitic steel such as AISI 329, 405, 410 and 430. They can also be used for welding titanium- and nobium-stabilized steels, e.g. 316Ti, in cases where the service temperature is below 400ºC.

II. DESCRIPTION:

NSS-316L-17 is a lime-titania type stainless steel electrode which gives an extra low carbon and virtually free from spatter. Because of extra low carbon content especially, the deposited metal has more excellent resistance to the intercystalline corrosion than that of ordinary 316 type. Due to excellent properties at high temperature, it is widely used in various chemical industries. Peeling-off of the slag is very good.

III. NOTES ON USAGE:

       Clean off dust or oil from the welding area in order to prevent from decreasing the corrosion resistance caused by interblending carbon to the deposited metal.

IV. TYPICAL CHEMICAL COMPOSITION OF WELD METAL (%):

 

C

Mn

Si

Ni

Cr

Mo

Cu

0.02

0.84

0.65

12.3

19.3

2.42

0.03

V. TYPICAL MECHANICAL PROPERTIES OF WELD METAL:

Tensile Strength

N/mm2 (Ksi)

Elongation

%

600 (87)

39

VI. WELDING POSITIONS: ALL POSITION-EXCEPT VERTICAL DOWN

VII. SIZES AVAILABLE AND RECOMMENDED CURRENTS (AC or DC + ):

 

Size

(mm)

Dia.

1.6

2.0

2.6

3.2

4.0

5.0

Length

250

250

300

350

350

350

Current

F

10-30

15-50

40-80

60-130

90-150

110-180

Range

V,OH

10-30

15-50

40-80

60-130

90-150

100-170

 

 TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.