nihonweldnihonweldnihonweld

Printer Friendly Layout
NIHONWELD N-33
AWS Specification: AWS A5.1 E6013
JIS Specification:

D4313

Other Specification:

PHIL MARKET ONLY

I. APPLICATIONS:

Welding of machines, vehicles and light structural steels. Surface dressing of heavy steel structures.

 

II. DESCRIPTIONS:

 

N-33 is a high titania type electrode, whose liability is excellent in all position welding. N-33 is especially suitable for welding of light structural steels because arc stability, slag detachability and bead appearance are good and its penetration is shallow.

 

III. NOTES ON USAGE:

(1) Pay attention not to exceed the range of proper currents. Welding with excessive current not only lowers X-ray soundness, but also causes increase of spatter, under-cut and insufficient slag covering.

(2) Dry the electrodes at 70-100 degrees C for 30-60 minutes before use. Excessive moisture absorption lowers usability and may result in some porosities.

(3) Excessive drying before use causes less in penetration and overheating of the electrode.

 

IV. TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%)

 

C

Mn

Si

P

S

0.08

0.35

0.27

0.016

0.011

V. TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS

 

Yield Point

N/mm2 (Kgf/mm2)

Tensile Strength

N/mm2 (Ksi)

Elongation

(%)

Impact Value

Deg C, J (Deg F, Ft-lbs)

430 (62)

480 (70)

28

0,65 (32,48)

VI. WELDING POSITIONS : FLAT, FILLET, VERTICAL UP, HORIZONTAL, OVERHEAD 

VII. SIZE & RECOMMENDED CURRENT RANGE: AC OR DC (+):

 

Diameter (mm)

2.5

3.2

4.0

5.0

Length (mm)

350

350

400

400

Ampere

Flat

55-95

80-130

125-175

170-230

V&OH

50-90

70-120

100-160

120-200

 

TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.