nihonweldnihonweldnihonweld

Printer Friendly Layout
NIHONWELD N-101
NIHONWELD N-101
AWS Specification: AWS A5.1 E6019
JIS Specification:

D4301

Other Specification:

DIN E4343AR7

 

I. APPLICATIONS:

Welding of heavy-duty structures such as ships, vehicles, buildings and bridges.

II. DESCRIPTIONS:

N-101 is a ilmenite type electrode designed for puting emphasis on both usability and weldability. It is suitable for butt or fillet welding in all positions for thin or thicker plates (1.6 to 20mm). In horizontal fillet welding, slag covering and bead uniformity are good and bead appearance is beautiful. Its usability is vertical or overhead welding is best among ilmenite type of electrodes.

III. NOTES ON USAGE:

  • Pay attention not to exceed the range of proper currents. Welding with excessive current not only lowers X-ray soundness, but also causes increase of spatter, under-cut and insufficient slag covering.

  • Dry the electrodes at 70-100°C for 30-60 minutes before use. Excessive moisture absorption lowers usability and may result in some porosities.

  • Excessive drying before use causes less in penetration and overheating of the electrode.

IV. TYPICAL CHEMICAL PROPERTIES OF ALL WELD METAL DEPOSIT(%):

 

C

Si

Mn

P

S

0.08

0.07

0.51

0.012

0.007

V. TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSIT:

 

Yield Point

N/mm2 (Ksi)

Tensile Strength

N/mm2 (Ksi)

Elongation

%

Impact Value

0 0C,J (0Ft-Lbs)

410 (60)

460 (67)

32

-18, 80 (0, 59)

VI. WELDING POSITIONS : ALL POSITIONS : 1G, 2F, 2G, 3G(UP), 4G 

VII. SIZE & RECOMMENDED CURRENT RANGE:AC or DC (+)

 

DIAMETER (mm)

2.6

3.2

4.0

5.0

LENGTH (mm)

350

350

400

400

CURRENT

A

F

50-85

80-130

120-180

170-250

V, OH

40-80

60-110

100-150

130-200

APPROVALS: ABS, BV,DNV, LRS

                                   

TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.